• WhatsApp: +86 178 6052 5713
LENJEX industrial ultrasonic cleaning equipment
Precision Components Cleaning industrial equipment

LENJEX Industrial Cleaning

Precision Components Cleaning

Precision cleaning is controlled by particle size, surface sensitivity, rinse quality, bath condition and handling after the wash.

Typical Workpieces

Parts in this application

  • Fine instruments
  • Optical hardware
  • Electronic components
  • Small precision assemblies

Contamination

Soils to evaluate

  • Fine particles
  • Light oil film
  • Polishing residue
  • Dust
Precision Components Cleaning process evaluation

Cleanliness Target

Define clean before choosing equipment

Requirements may include particle counts, nonvolatile residue, water-break condition or controlled visual inspection.

The acceptance method should be practical for trials and production, with agreed sample handling and inspection timing.

Recommended Sequence

A process route for evaluation

The final sequence depends on soil loading, part material, rinse quality and drying behavior.

  1. Step 1Application-matched ultrasonic wash
  2. Step 2Filtered or DI-water rinse
  3. Step 3Controlled drainage
  4. Step 4Clean hot-air or application-specific drying
  5. VerifyInspect against the agreed cleanliness method.

Recommended Equipment

Systems to compare

These equipment families support the application review; the final specification follows process testing and production analysis.

Process Controls

Control the variables that change the cleaning result

Confirm the part, soil, loading and final handling before fixing equipment settings.

Control 01

Material and geometry

Record surfaces, cavities and features that can trap air or liquid.

Control 02

Soil condition

Test the heaviest representative contamination, not an ideal sample.

Control 03

Basket loading

Keep acoustic access and part spacing consistent with production.

Control 04

Rinse and drying

Match downstream handling to residue and corrosion risks.

System Selection

Match the cleaning route to production flow

Stage count and automation follow the validated process and required output.

Batch

Single-tank route

Compare for focused washing where rinsing and drying are managed separately.

Multi-stage

Wash, rinse and dry

Add controlled stages when carryover and final condition matter.

Automatic

Repeatable transfer

Evaluate automation when output, handling or recipe control requires it.

Acceptance

Define how the cleaned part will be checked

Use the same practical inspection method for trial samples and production parts.

  • Agree the surface or residue limit
  • Check hidden and difficult features
  • Record rinse, drying and handling conditions
  • Compare results before the next operation

Representative Trial

Confirm the process with real parts and loads

Trial evidence should cover normal production and the most difficult expected condition.

  1. DescribePart, material and contamination.
  2. LoadUse realistic spacing and orientation.
  3. TestRecord chemistry, time and temperature.
  4. VerifyInspect with the agreed method.
Plan a cleaning trialSend project details

Application Questions

Planning the cleaning study